c0f61e4aac
- Reverted back the serial RX count function to how it was. The variable type was unsigned and cause an integer underflow whenever the calculation produced a negative number. The old way was the correct way. - Lots of minor edits to the code CSVs and markdown documents. - Expanded on explaining feedback messages and startup line execution feedback. - Created a new settings codes CSV to help GUIs import the values and meanings.
1.1 KiB
1.1 KiB
| 1 | (KEY: Alarm Code in v1.1+, Alarm Message in v1.0-, Alarm Description) |
|---|---|
| 2 | 1,Hard limit,Hard limit has been triggered. Machine position is likely lost due to sudden halt. Re-homing is highly recommended. |
| 3 | 2,Soft limit,Soft limit alarm. G-code motion target exceeds machine travel. Machine position retained. Alarm may be safely unlocked. |
| 4 | 3,Abort during cycle,Reset while in motion. Machine position is likely lost due to sudden halt. Re-homing is highly recommended. |
| 5 | 4,Probe fail,Probe fail. Probe is not in the expected initial state before starting probe cycle when G38.2 and G38.3 is not triggered and G38.4 and G38.5 is triggered. |
| 6 | 5,Probe fail,Probe fail. Probe did not contact the workpiece within the programmed travel for G38.2 and G38.4. |
| 7 | 6,Homing fail,Homing fail. The active homing cycle was reset. |
| 8 | 7,Homing fail,Homing fail. Safety door was opened during homing cycle. |
| 9 | 8,Homing fail,Homing fail. Pull off travel failed to clear limit switch. Try increasing pull-off setting or check wiring. |
| 10 | 9,Homing fail,Homing fail. Could not find limit switch within search distances. Try increasing max travel, decreasing pull-off distance, or check wiring. |