- Added another way to further ensure the long slope deceleration issue
is eliminated. If the stepper rate change is too great near zero, the
stepper rate is adjusted at half increments to the end of travel,
creating a smooth transition. - If the new STEPPER_IDLE_LOCK_TIME is
set as zero, this delay is not compiled at compile-time. - NOTE: The
next update is likely going to be major, involving a full re-write of
the stepper.c program to integrate a simple way to apply pauses,
jogging, e-stop, and feedrate overrides. The interface should be
flexible enough to be easily modified for use with either hardware
switches or software commands. Coming soon.
This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.
h1. Grbl - An embedded g-code interpreter and motion-controller for the Arduino/AVR328 microcontroller
Grbl is a no-compromise, high performance, low cost alternative to parallel-port-based motion control for CNC milling. It will run on a vanilla Arduino (Duemillanove/Uno) as long as it sports an Atmega 328.
The controller is written in highly optimized C utilizing every clever feature of the AVR-chips to achieve precise timing and asynchronous operation. It is able to maintain more than 30kHz of stable, jitter free control pulses.
It accepts standards-compliant G-code and has been tested with the output of several CAM tools with no problems. Arcs, circles and helical motion are fully supported - but no support for tool offsets, functions or variables as these are apocryphal and fell into disuse after humans left G-code authoring to machines some time in the 80s.
Grbl includes full acceleration management with look ahead. That means the controller will look up to 20 motions into the future and plan its velocities ahead to deliver smooth acceleration and jerk-free cornering.
*Important note for Atmega 168 users:* Grbl used to be compatible with both the older Ardunios running atmega 168 and the newer with 328p. The full version of Grbl now compiles without support for circles/arcs if you target 168. If you need arcs, but not acceleration-management I am still maintaining Grbl 0.51 "in the branch called 'v0_51'":https://github.com/simen/grbl/tree/v0_51.
*Note for users upgrading from 0.51 to 0.6:* The new version has new and improved default pin-out. If nothing works when you upgrade, that is because the pulse trains are coming from the wrong pins. This is a simple matter of editing config.h – the whole legacy pin assignment is there for you to uncomment.
_The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery_
ca26bb9ccf