ManuelW/grbl-LPC-CoreXY
1
0
Fork 0
Code Issues Pull Requests Releases 1 Wiki Activity

Fixed config.h to Grbl release defaults.

Browse Source 
- REPORT_GUI_MODE was accidentally enabled, when it shouldn’t have.
This commit is contained in:
Sonny Jeon 2015-02-23 18:50:32 -07:00
parent c7db1c4546
commit d4ae8f94af
1 changed files with 3 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

5
grbl/config.h
View File

@ -174,8 +174,9 @@
// Enables minimal reporting feedback mode for GUIs, where human-readable strings are not as important. // Enables minimal reporting feedback mode for GUIs, where human-readable strings are not as important.
// This saves nearly 2KB of flash space and may allow enough space to install other/future features. // This saves nearly 2KB of flash space and may allow enough space to install other/future features.
// GUIs will need to install a look-up table for the error-codes that Grbl sends back in their place.
// NOTE: This feature is new and experimental. Make sure the GUI you are using supports this mode. // NOTE: This feature is new and experimental. Make sure the GUI you are using supports this mode.
#define REPORT_GUI_MODE // Default disabled. Uncomment to enable. // #define REPORT_GUI_MODE // Default disabled. Uncomment to enable.
// The temporal resolution of the acceleration management subsystem. A higher number gives smoother // The temporal resolution of the acceleration management subsystem. A higher number gives smoother
// acceleration, particularly noticeable on machines that run at very high feedrates, but may negatively // acceleration, particularly noticeable on machines that run at very high feedrates, but may negatively
@ -226,7 +227,7 @@
// enable pin will output 5V for maximum RPM with 256 intermediate levels and 0V when disabled. // enable pin will output 5V for maximum RPM with 256 intermediate levels and 0V when disabled.
// NOTE: IMPORTANT for Arduino Unos! When enabled, the Z-limit pin D11 and spindle enable pin D12 switch! // NOTE: IMPORTANT for Arduino Unos! When enabled, the Z-limit pin D11 and spindle enable pin D12 switch!
// The hardware PWM output on pin D11 is required for variable spindle output voltages. // The hardware PWM output on pin D11 is required for variable spindle output voltages.
#define VARIABLE_SPINDLE // Default disabled. Uncomment to enable. #define VARIABLE_SPINDLE // Default enabled. Comment to disable.
// Used by the variable spindle output only. These parameters set the maximum and minimum spindle speed // Used by the variable spindle output only. These parameters set the maximum and minimum spindle speed
// "S" g-code values to correspond to the maximum and minimum pin voltages. There are 256 discrete and // "S" g-code values to correspond to the maximum and minimum pin voltages. There are 256 discrete and