From d4ae8f94aff41a8b8a70e7bf0ee1387334fa354d Mon Sep 17 00:00:00 2001 From: Sonny Jeon Date: Mon, 23 Feb 2015 18:50:32 -0700 Subject: [PATCH] Fixed config.h to Grbl release defaults. MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit - REPORT_GUI_MODE was accidentally enabled, when it shouldn’t have. --- grbl/config.h | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/grbl/config.h b/grbl/config.h index 297742e..cde5065 100644 --- a/grbl/config.h +++ b/grbl/config.h @@ -174,8 +174,9 @@ // Enables minimal reporting feedback mode for GUIs, where human-readable strings are not as important. // This saves nearly 2KB of flash space and may allow enough space to install other/future features. +// GUIs will need to install a look-up table for the error-codes that Grbl sends back in their place. // NOTE: This feature is new and experimental. Make sure the GUI you are using supports this mode. -#define REPORT_GUI_MODE // Default disabled. Uncomment to enable. +// #define REPORT_GUI_MODE // Default disabled. Uncomment to enable. // The temporal resolution of the acceleration management subsystem. A higher number gives smoother // acceleration, particularly noticeable on machines that run at very high feedrates, but may negatively @@ -226,7 +227,7 @@ // enable pin will output 5V for maximum RPM with 256 intermediate levels and 0V when disabled. // NOTE: IMPORTANT for Arduino Unos! When enabled, the Z-limit pin D11 and spindle enable pin D12 switch! // The hardware PWM output on pin D11 is required for variable spindle output voltages. -#define VARIABLE_SPINDLE // Default disabled. Uncomment to enable. +#define VARIABLE_SPINDLE // Default enabled. Comment to disable. // Used by the variable spindle output only. These parameters set the maximum and minimum spindle speed // "S" g-code values to correspond to the maximum and minimum pin voltages. There are 256 discrete and