2010-06-18 21:45:17 +02:00
|
|
|
Grbl - an open source, embedded high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino.
|
|
|
|
|
|
|
|
|
|
Documentation: http://dank.bengler.no/-/page/show/5470_grbl
|
2010-07-02 22:40:26 +02:00
|
|
|
Dev announcments on twitter @grblcnc: http://twitter.com/grblcnc
|
2009-01-25 00:48:56 +01:00
|
|
|
|
2009-02-08 12:30:47 +01:00
|
|
|
Status:
|
2010-03-04 21:39:49 +01:00
|
|
|
* Ready for production, but probably rough around the edges still
|
|
|
|
|
* Highly optimized C utilizing the hardware-timers of the AVR-chip for all critical timing
|
|
|
|
|
* Able to maintain more than 30kHz step rate, generating an ultra clean, jitter free step-signal
|
|
|
|
|
* G-code interpreter complete, tested with output from several CAM tools
|
|
|
|
|
* Standards-compliant g-code arcs/circles fully supported
|
|
|
|
|
* Buffered, non blocking, asynchronous step generation so the rest of the system is free to process
|
|
|
|
|
g-code while the steppers are steppin'
|
2010-03-07 20:29:18 +01:00
|
|
|
* Configuration parameters stored in EEPROM and set via simple commands
|
2010-03-04 21:39:49 +01:00
|
|
|
* Tested on very few (two) CNC rigs
|
2010-01-06 00:31:11 +01:00
|
|
|
|
2010-06-18 21:45:17 +02:00
|
|
|
Limitations by design:
|
|
|
|
|
* Limited GCode-support. Focus on the kind of GCode produced by CAM tools. Leave human GCoders frustrated.
|
|
|
|
|
* No support for tool offsets (typically handled by CAM-tool)
|
|
|
|
|
* No rotation axes, only x, y and z.
|
|
|
|
|
|
2010-03-07 20:41:16 +01:00
|
|
|
Prioritized to-do:
|
|
|
|
|
* Accelleration/decelleration
|
|
|
|
|
* Spindle control
|
|
|
|
|
* Autodetect baud rate
|
|
|
|
|
* Arduino IDE compatible (build and flash)
|
2010-03-04 21:39:49 +01:00
|
|
|
* Documentation and web-site
|
2010-03-07 20:41:16 +01:00
|
|
|
* Support for a alphanumeric LCD readout, a joystick and a few buttons for program control
|
2010-01-06 00:31:11 +01:00
|
|
|
* Support "headless" fabrication by buffering all code to SD-card or similar
|
2009-02-08 12:30:47 +01:00
|
|
|
|
2010-03-04 21:39:49 +01:00
|
|
|
The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery
|
