e51e691eeb
- Incremented to v1.1a, rather than keep 1.0e. This is because there are existing v1.0 installations. Don’t want to confuse people further. - Certain version of the Arduino IDE did not like the `inline` in the function header. Removed from spindle_control files to fix the problem. - Tweaked the communication protocol slightly. Added message type indicators for all `[]`bracketed feedback messages. It’s been problematic for GUI dev to try to determine the context of a message and how it should be handled. These indictors should help tremendously to remove context all together. - Also altered how `$N` startup lines are presented when executed. They now start with an open chevron ‘>’ followed by the line and an ‘:ok’ to indicate it executed. The ‘ok’ is on the same line intentionally so it doesn’t mess up a streaming protocol counter. - Managed to save a 100+KB from refactoring parts of report.c. (Thanks Vasilis!) Freed up room to alter the protocol a little. - Wrote a markdown document on interface messaging to make it clear how it’s intended to work. See interface.md in /doc/markdown - Started to pull in some Wiki pages from the old grbl site and beginning to update them for v1.1. - Created new commit log for v1.1.
44 lines
1.5 KiB
C
44 lines
1.5 KiB
C
/*
|
|
spindle_control.h - spindle control methods
|
|
Part of Grbl
|
|
|
|
Copyright (c) 2012-2016 Sungeun K. Jeon for Gnea Research LLC
|
|
Copyright (c) 2009-2011 Simen Svale Skogsrud
|
|
|
|
Grbl is free software: you can redistribute it and/or modify
|
|
it under the terms of the GNU General Public License as published by
|
|
the Free Software Foundation, either version 3 of the License, or
|
|
(at your option) any later version.
|
|
|
|
Grbl is distributed in the hope that it will be useful,
|
|
but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
GNU General Public License for more details.
|
|
|
|
You should have received a copy of the GNU General Public License
|
|
along with Grbl. If not, see <http://www.gnu.org/licenses/>.
|
|
*/
|
|
|
|
#ifndef spindle_control_h
|
|
#define spindle_control_h
|
|
|
|
|
|
// Initializes spindle pins and hardware PWM, if enabled.
|
|
void spindle_init();
|
|
|
|
// Called by g-code parser when setting spindle state and requires a buffer sync.
|
|
void spindle_run(uint8_t direction, float rpm);
|
|
|
|
// Immediately sets spindle running state with direction and spindle rpm via PWM, if enabled.
|
|
// Called by spindle_run() after sync and parking motion/spindle stop override during restore.
|
|
void spindle_set_state(uint8_t state, uint8_t pwm_value);
|
|
|
|
// Stop and start spindle routines. Called by all spindle routines and stepper ISR.
|
|
void spindle_stop();
|
|
void spindle_set_speed(uint8_t pwm_value); // Variable spindle only.
|
|
|
|
uint8_t spindle_compute_pwm_value(float rpm); // 328p PWM register is 8-bit. Variable spindle only.
|
|
|
|
|
|
#endif
|