27 lines
1.5 KiB
Plaintext
27 lines
1.5 KiB
Plaintext
h1. Grbl - An embedded g-code interpreter and motion-controller for the Arduino/AVR328 microcontroller
|
|
|
|
h2. The goal: A no-compromise, high performance, low cost alternative to parallel-port based motion control for CNC milling
|
|
|
|
h2. Status:
|
|
|
|
* Ready for production, used regularly for countless CNC jobs
|
|
* Highly optimized C utilizing the hardware-timers of the AVR-chip for all critical timing
|
|
* Able to maintain more than 30kHz step rate, generating an ultra clean, jitter free step-signal
|
|
* Robust G-code interpreter, tested with output from several CAM tools
|
|
* Standards-compliant g-code arcs/circles fully supported
|
|
* Buffered, non blocking, asynchronous step generation so the rest of the system is free to process
|
|
g-code while the steppers are steppin'
|
|
* Configuration parameters stored in EEPROM and set via simple commands
|
|
* Full acceleration management with look-ahead
|
|
** Smooth acceleration and deceleration lets stepper motors run at higher nominal speeds
|
|
** Smooth cornering within the set jerk-limit of your choosing will brake for sharp turns, but keep speed at slight direction changes
|
|
|
|
Prioritized to-do:
|
|
* Backlash compensation
|
|
* Autodetect baud rate
|
|
* Spindle control
|
|
* Arduino IDE compatible (build and flash)
|
|
* Support "headless" fabrication by buffering all code to SD-card or similar
|
|
|
|
The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery
|