16 lines
813 B
Plaintext
16 lines
813 B
Plaintext
* Optimize arc target detection code utilizing the primary axis of travel
|
|
* Use bitmasks, not vectors to build steps in motion_control
|
|
* Arcs might be a step or two off because of FP gotchas. Must add a little nudge in the end there
|
|
* Generalize feed rate code and support inverse feed rate for arcs
|
|
* Implement homing cycle in stepper.c
|
|
* Implement limit switch support in stepper.c (use port-triggered interrupts?)
|
|
* How to implement st_set_pace? Consider synchronizing when pace is changed
|
|
* How on earth am I going to deal with arcs in setups that have different steps/mm on each axis? Must
|
|
support elipses?! Oh no.
|
|
* Support helical interpolation
|
|
* Eliminate need for circle_x and circle_y in step_arc_along_
|
|
* Tool table
|
|
* Tool length offsets
|
|
* Tool change M6
|
|
* Path Control Modes
|
|
* Spindle speed support |