9cabc915ef
- Pinned out cycle start(A2), feed hold(A1), and reset(A0) runtime commands. These pins are held high with the internal pull-up resistor enabled. All you have to do is connect a normally-open switch to the pin and ground. That's it. - Moved the coolant control pins to A3 (and the optional mist control to A4). - Moved all of the MASK defines into the config.h file to centralize them.
53 lines
1.6 KiB
C
Executable File
53 lines
1.6 KiB
C
Executable File
/*
|
|
stepper.h - stepper motor driver: executes motion plans of planner.c using the stepper motors
|
|
Part of Grbl
|
|
|
|
Copyright (c) 2009-2011 Simen Svale Skogsrud
|
|
Copyright (c) 2011 Sungeun K. Jeon
|
|
|
|
Grbl is free software: you can redistribute it and/or modify
|
|
it under the terms of the GNU General Public License as published by
|
|
the Free Software Foundation, either version 3 of the License, or
|
|
(at your option) any later version.
|
|
|
|
Grbl is distributed in the hope that it will be useful,
|
|
but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
GNU General Public License for more details.
|
|
|
|
You should have received a copy of the GNU General Public License
|
|
along with Grbl. If not, see <http://www.gnu.org/licenses/>.
|
|
*/
|
|
|
|
#ifndef stepper_h
|
|
#define stepper_h
|
|
|
|
#include <avr/io.h>
|
|
|
|
// Some useful constants
|
|
#define TICKS_PER_MICROSECOND (F_CPU/1000000)
|
|
#define CYCLES_PER_ACCELERATION_TICK ((TICKS_PER_MICROSECOND*1000000)/ACCELERATION_TICKS_PER_SECOND)
|
|
|
|
// Initialize and setup the stepper motor subsystem
|
|
void st_init();
|
|
|
|
// Enable steppers, but cycle does not start unless called by motion control or runtime command.
|
|
void st_wake_up();
|
|
|
|
// Immediately disables steppers
|
|
void st_go_idle();
|
|
|
|
// Reset the stepper subsystem variables
|
|
void st_reset();
|
|
|
|
// Notify the stepper subsystem to start executing the g-code program in buffer.
|
|
void st_cycle_start();
|
|
|
|
// Reinitializes the buffer after a feed hold for a resume.
|
|
void st_cycle_reinitialize();
|
|
|
|
// Initiates a feed hold of the running program
|
|
void st_feed_hold();
|
|
|
|
#endif
|