* Use errno to detect fp-errors
* Optimize arc target detection code utilizing the primary axis of travel
* Arcs might be a step or two off because of FP gotchas. Must add a little nudge in the end there?
* Implement homing cycle in stepper.c
* Implement limit switch support in stepper.c (use port-triggered interrupts?)
* How on earth am I going to deal with arcs in setups that have different steps/mm on each axis? Must 
  support elipses?! Oh no.
* Eliminate need for x and y in step_arc_along_
* Tool table
* Tool length offsets
* Tool change M6
* Path Control Modes
* Spindle speed support

Bugs to fix:

This generates an infinite sequence of non-steppings
G01 X152.730364 Y331.534522
G03 X152.30001 Y331.959998 I-1.959917 J-1.552007