ManuelW/grbl-LPC-CoreXY
1
0
Fork 0
Code Issues Pull Requests Releases 1 Wiki Activity

More minor bug fixes in planner.

Browse Source 
Reverse planner was over-writing the initial/buffer tail entry speed,
which reset the forward planner and caused it to lose track of its
speed. Should now accelerate into short linear segments much nicer now.
This commit is contained in:
Sonny J 2011-09-04 11:19:08 -06:00
parent 5e2e935bda
commit f1e5ff35ec
1 changed files with 19 additions and 19 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

18
planner.c
View File

@ -100,12 +100,13 @@ static double max_allowable_speed(double acceleration, double target_velocity, d
static void planner_reverse_pass_kernel(block_t *previous, block_t *current, block_t *next) {
if (!current) { return; }
double entry_speed = current->max_entry_speed;
if (previous) { // Prevent reverse planner from over-writing buffer_tail entry speed.
double entry_speed = current->max_entry_speed; // Re-write to ensure at max possible speed
double exit_speed;
if (next) {
exit_speed = next->entry_speed;
} else {
exit_speed = 0.0;
exit_speed = 0.0; // Assume last block has zero exit velocity
}
// If the required deceleration across the block is too rapid, reduce the entry_factor accordingly.
if (entry_speed > exit_speed) {
@ -113,6 +114,7 @@ static void planner_reverse_pass_kernel(block_t *previous, block_t *current, blo
min(max_allowable_speed(-settings.acceleration,exit_speed,current->millimeters),entry_speed);
}
current->entry_speed = entry_speed;
}
}
@ -354,19 +356,17 @@ void plan_buffer_line(double x, double y, double z, double feed_rate, int invert
-previous->delta_mm[Z_AXIS] * block->delta_mm[Z_AXIS] )/
( previous->millimeters * block->millimeters );
// Avoid divide by zero for straight junctions around 180 degress
// Avoid divide by zero for straight junctions near 180 degrees. Limit to min nominal speeds.
vmax_junction = min(previous->nominal_speed,block->nominal_speed);
if (cos_theta > -0.95) {
// Compute maximum junction velocity based on maximum acceleration and junction deviation
double sin_theta_d2 = sqrt((1-cos_theta)/2); // Trig half angle identity
vmax_junction =
sqrt(settings.acceleration*60*60 * settings.junction_deviation * sin_theta_d2/(1-sin_theta_d2));
vmax_junction = max(0.0,min(vmax_junction, min(previous->nominal_speed,block->nominal_speed)));
} else {
vmax_junction = min(previous->nominal_speed,block->nominal_speed);
vmax_junction = max(0.0, min(vmax_junction,
sqrt(settings.acceleration*60*60 * settings.junction_deviation * sin_theta_d2/(1-sin_theta_d2)) ) );
}
}
block->max_entry_speed = vmax_junction;
block->entry_speed = 0.0;
block->entry_speed = vmax_junction;
} else {
block->initial_rate = block->nominal_rate;
block->final_rate = block->nominal_rate;