diff --git a/Makefile b/Makefile
index ab8c9ec..9bc5615 100644
--- a/Makefile
+++ b/Makefile
@@ -36,8 +36,6 @@ OBJECTS    = main.o motion_control.o gcode.o spindle_control.o coolant_control.o
              print.o probe.o report.o system.o
 # FUSES      = -U hfuse:w:0xd9:m -U lfuse:w:0x24:m
 FUSES      = -U hfuse:w:0xd2:m -U lfuse:w:0xff:m
-# update that line with this when programmer is back up:
-# FUSES      = -U hfuse:w:0xd7:m -U lfuse:w:0xff:m
 
 # Tune the lines below only if you know what you are doing:
 
diff --git a/report.c b/report.c
index 54c6073..50af386 100644
--- a/report.c
+++ b/report.c
@@ -379,6 +379,11 @@ void report_realtime_status()
     case STATE_CHECK_MODE: printPgmString(PSTR("<Check")); break;
   }
  
+  // If reporting a position, convert the current step count (current_position) to millimeters.
+  if (bit_istrue(settings.status_report_mask,(BITFLAG_RT_STATUS_MACHINE_POSITION | BITFLAG_RT_STATUS_WORK_POSITION)) {
+    for (i=0; i< N_AXIS; i++) { print_position[i] = current_position[i]/settings.steps_per_mm[i]; }
+  }
+  
   // Report machine position
   if (bit_istrue(settings.status_report_mask,BITFLAG_RT_STATUS_MACHINE_POSITION)) {
     printPgmString(PSTR(",MPos:")); 
@@ -388,7 +393,6 @@ void report_realtime_status()
 //     print_position[X_AXIS] -= print_position[Z_AXIS];    
 //     print_position[Z_AXIS] = current_position[Z_AXIS]/settings.steps_per_mm[Z_AXIS];     
     for (i=0; i< N_AXIS; i++) {
-      print_position[i] = current_position[i]/settings.steps_per_mm[i];
       printFloat_CoordValue(print_position[i]);
       if (i < (N_AXIS-1)) { printPgmString(PSTR(",")); }
     }
@@ -398,6 +402,7 @@ void report_realtime_status()
   if (bit_istrue(settings.status_report_mask,BITFLAG_RT_STATUS_WORK_POSITION)) {
     printPgmString(PSTR(",WPos:")); 
     for (i=0; i< N_AXIS; i++) {
+      // Apply work coordinate offsets and tool length offset to current position.
       print_position[i] -= gc_state.coord_system[i]+gc_state.coord_offset[i];
       if (i == TOOL_LENGTH_OFFSET_AXIS) { print_position[i] -= gc_state.tool_length_offset; }    
       printFloat_CoordValue(print_position[i]);