New startup script setting. New dry run, check gcode switches. New system state variable. Lots of reorganizing.

(All v0.8 features installed. Still likely buggy, but now thourough
testing will need to start to squash them all. As soon as we're done,
this will be pushed to master and v0.9 development will be started.
Please report ANY issues to us so we can get this rolled out ASAP.)

- User startup script! A user can now save one (up to 5 as compile-time
option) block of g-code in EEPROM memory. This will be run everytime
Grbl resets. Mainly to be used as a way to set your preferences, like
G21, G54, etc.

- New dry run and check g-code switches. Dry run moves ALL motions at
rapids rate ignoring spindle, coolant, and dwell commands. For rapid
physical proofing of your code. The check g-code switch ignores all
motion and provides the user a way to check if there are any errors in
their program that Grbl may not like.

- Program restart! (sort of). Program restart is typically an advanced
feature that allows users to restart a program mid-stream. The check
g-code switch can perform this feature by enabling the switch at the
start of the program, and disabling it at the desired point with some
minimal changes.

- New system state variable. This state variable tracks all of the
different state processes that Grbl performs, i.e. cycle start, feed
hold, homing, etc. This is mainly for making managing of these task
easier and more clear.

- Position lost state variable. Only when homing is enabled, Grbl will
refuse to move until homing is completed and position is known. This is
mainly for safety. Otherwise, it will let users fend for themselves.

- Moved the default settings defines into config.h. The plan is to
eventually create a set of config.h's for particular as-built machines
to help users from doing it themselves.

- Moved around misc defines into .h files. And lots of other little
things.

gcode.h

@@ -62,8 +62,19 @@
 #define NON_MODAL_SET_COORDINATE_OFFSET 7 // G92
 #define NON_MODAL_RESET_COORDINATE_OFFSET 8 //G92.1
 
+// Define bit flag masks for gc.switches. (8 flag limit)
+#define BITFLAG_CHECK_GCODE   bit(0)
+#define BITFLAG_DRY_RUN       bit(1)
+#define BITFLAG_BLOCK_DELETE  bit(2)
+#define BITFLAG_SINGLE_BLOCK  bit(3)
+#define BITFLAG_OPT_STOP      bit(4)
+// #define                    bit(5)
+// #define                    bit(6)
+// #define                    bit(7)
+
 typedef struct {
   uint8_t status_code;             // Parser status for current block
+  uint8_t switches;                // Handles non-gcode switches modes. Set externally by protocol. Default off
   uint8_t motion_mode;             // {G0, G1, G2, G3, G80}
   uint8_t inverse_feed_rate_mode;  // {G93, G94}
   uint8_t inches_mode;             // 0 = millimeter mode, 1 = inches mode {G20, G21}