ManuelW/grbl-LPC-CoreXY
1
0
Fork 0
Code Issues Pull Requests Releases 1 Wiki Activity

updated readme

Browse Source
This commit is contained in:
Simen Svale Skogsrud 2010-06-18 21:45:17 +02:00
parent 937c70cb50
commit 0170ba0dc5
1 changed files with 8 additions and 7 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

15
readme.txt
View File

@ -1,5 +1,6 @@
Grbl - An embedded rs274/ngc (g-code) interpreter and motion-controller for the Arduino/AVR328 microcontroller Grbl - an open source, embedded high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino.
The goal: A no-compromise, high performance, low cost alternative to parallel-port based motion control for CNC milling
Documentation: http://dank.bengler.no/-/page/show/5470_grbl
Status: Status:
* Ready for production, but probably rough around the edges still * Ready for production, but probably rough around the edges still
@ -12,6 +13,11 @@ Status:
* Configuration parameters stored in EEPROM and set via simple commands * Configuration parameters stored in EEPROM and set via simple commands
* Tested on very few (two) CNC rigs * Tested on very few (two) CNC rigs
Limitations by design:
* Limited GCode-support. Focus on the kind of GCode produced by CAM tools. Leave human GCoders frustrated.
* No support for tool offsets (typically handled by CAM-tool)
* No rotation axes, only x, y and z.
Prioritized to-do: Prioritized to-do:
* Accelleration/decelleration * Accelleration/decelleration
* Spindle control * Spindle control
@ -21,9 +27,4 @@ Prioritized to-do:
* Support for a alphanumeric LCD readout, a joystick and a few buttons for program control * Support for a alphanumeric LCD readout, a joystick and a few buttons for program control
* Support "headless" fabrication by buffering all code to SD-card or similar * Support "headless" fabrication by buffering all code to SD-card or similar
Limitations by design:
* Limited GCode-support. Focus on the kind of GCode produced by CAM tools. Leave human GCoders frustrated.
* No support for tool offsets (typically handled by CAM-tool)
* No rotation axes, only x, y and z.
The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery