{{ _('Fan Speed Control') }}

{{ _('Set the default value for the speed slider.') }}

%
{{ _('The default value the slider will be set to when opening OctoPrint\'s UI') }}

{{ _('The settings below can be used to limit the fan\'s output, this is useful if your slicer doesn\'t allow min / max fan speeds.') }}

%
{{ _('Any value set by the slicer which is below this value will be increased to meet this speed.') }}
%
{{ _('Any value set by the slicer which is above this value will be decreased to meet this speed.') }}

{{ _('NOTE: The min/max setting has no effect when you are printing from an SD card attached directly to the printer as the gcode does not pass through OctoPrint. In the case of printing from SD, you will be required to use a slicer that allows for seting the min / max speed.') }}