{{ _('Fan Speed Control') }}

%
{{ _('The default value the slider will be set to when opening OctoPrint\'s UI') }}
{{ _('Instead of the default speed value, the slider will use the last sent speed as the default value') }}
%
{{ _('Any value sent which is below this value will be increased to meet this speed. Useful if your fan doesn\'t work below a certain threshold.') }}
%
{{ _('Any value sent which is above this value will be decreased to meet this speed. Useful if your fan is too strong on full speed.') }}

{{ _('NOTE: The min/max setting has no effect when you are printing from an SD card that is attached directly to the printer as the gcode does not pass through OctoPrint.') }}

{{ _('Disables cooling fan commands from reaching the printer. Use with caution. (This performs the same function as the padlock button in the fan section of the controls page)') }}

{{ _('Notification Auto Hide Delay') }}

ms
{{ _('Delay (in milliseconds) before notifications are auto-hidden. Set to 0 to disable notifications.') }}